Roof waterproofing company waterproofing company _ _ Zhengzhou waterproof Oukai

 External wall insulation construction detail node infiltration, leakage prevention (1) should minimize the sub-grid of the set, in the construction of sub-grid section will be dedicated grooved insulation board cut notches, do not be EPS board cut through, and then veneered. (2) For external insulation on top of the wall or windowsill daughter shut the formation of "overturned stitch" caused by seepage, leakage problems should be shut at the outer insulation made of concrete or mortar capping Puyang waterproof insulation company, and then to strengthen the anti-mesh bag, crack After the mortar surface (3) In order to ensure the quality of the external walls or windows shut, indoor water companies to reduce leakage points, you can use gagged construction, in order to strengthen the inspection of construction quality of the hole and control. Avoid exterior walls should be installed on the window frame opening under direct drilling fixed sash. (4) After the construction of rainwater pipes attached to the wall, shutters, etc., causing the fixing member infiltration, leakage, should be done in advance before the outer insulation construction. Exterior wall tile grouts have to do during the construction of several tile grouts have water impermeability and anti-fungal, there was the role of the external walls of decorative landscaping. In order to fully reflect the role of tile grouts, waterproofing company Shanghai waterproofing company reminds us, at the time of construction exterior wall tile grouts must do the following. 1. Surface treatment: Using tile grouts are advised to clean tile gap, remove all dirt, grease and other contaminants. But also to remove the gap between the tiles loose tile adhesive. 2, mixing: use with a suitable low-speed electric drill mixing blade mechanical stirring. Adding an appropriate amount of water to the powder, then stir in Henan start waterproofing company, until evenly until no lumps. Mixture to be standing 5min. Can be used again after a little stirring. 3. Construction: pointing a knife or rubber spatula appropriate. The stirred tile grouts fill in the tile gap, according to the diagonal direction or rotate in a circular manner tile grouts to fill the gap. Tile surface is not possible residual excess grouts, and before solidification materials regularly with a damp sponge or damp cloth to clean the tile surface. Clear as soon as any defects found in good condition and repair as soon as possible. 4. Cleaning: Use a slightly damp sponge to clean tile surface, use a clean damp cloth to wipe the local and sealant film before drying. After the tool should immediately rinse with water. Tile grouts after initial curing dry with a dry cloth surface has been chalking tile grouts wipe or clean water for the final. Finally, note that when using tile grouts, one can not modulate excessive, depending on the amount of construction may be, if there is not used to agglomerate, can not continue to use. Roof waterproofing company waterproofing company _ _ provided by the Zhengzhou Zhengzhou Oukai Oukai waterproof waterproof Engineering Limited. Zhengzhou Oukai waterproof Engineering Limited (www.zzfsgc.com) (www.zzfsgc.com) strong, credible, in Zhengzhou, Henan Province of waterproof, moisture-proof materials industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Zhengzhou Oukai waterproof and you hand into the brilliant, for a better future!