Supply 40w 50w 60w 70w 80w 100w 120w 150WLED explosion proof floodlight lamps _LED

 Explosion proof LED floodlight 100W LED Flood Light LED explosion proof LED floodlight projection lamp explosion proof LED Flood Light 100W LED projection lamp 40w 50w 60w 70w 80w 100w 120w 150WLED explosion proof LED lights _LED proof floodlight Floodlight Lamp LED Flood Light Explosion, also known as LED explosion proof floodlight, LED projection lamp explosion. Proof LED floodlight by controlling the built-in microchip, the existing two types of products, using a combination of power-type chip, more stable performance, a huge single powerful product structure, can achieve high power, large distances can be cast light. Application areas: ● suitable for a variety of flammable and explosive, and outdoor work, the construction site and equipment, facilities and other places for a large area flood lighting. Structural features: ● excellent explosion-proof design to ensure that products can be safely used in a variety of flammable and explosive. ● shell protection grade IP66, waterproof performance, can resist the impact of surging waves. ● overall structure design, lightweight, good impact resistance, can be reliable and stable work under vibration environments. ● Precise optical design, with high purity aluminum reflector mirror and realize large range of floodlighting, lighting efficiency up to 77%, higher than the industry average of 30%. ● Electrical matching system design optimization, so that the lamp up to 90% electrical efficiency, power factor of 0.9. ● Efficient LED solid-state light source into the product, high luminous efficiency, long life, not only effectively improve work efficiency, but also reduce the amount of maintenance products. ● monolithic structure, a wide range of adjustable lighting angle, with a special cover electrical maintenance, easy installation and maintenance. ● Advanced shell anti-corrosion coating, corrosion level reached WF2, to ensure that lighting does not corrode in the salt spray and other harsh environments. Notes 1. The regular folding eliminate dust and dirt on the housing explosion-proof lighting, light fixtures to improve efficiency and thermal performance. Cleaning methods according to the lamp housing protection, the use of water (mark on the lamp shade above) or wipe with a damp cloth. When water cleaning, should cut off the power, scrub with a dry cloth is strictly prohibited lighting plastic (transparent parts), to prevent static electricity. 2. Check whether the highly transparent pieces of foreign material impact marks, loose safety net, sealing off corrosion. If so, should stop using, and timely maintenance and replacement. 3. The light damage should be lights, notice replaced, so the light source can not start leaving the ballast and other electrical components in an abnormal state long. Lighting lamps used in the cavity 4. moist environment if water should be promptly removed, replace the seal member, make sure the shell protective properties. 5. When the cover is opened, the requirements should be warning signs, after opening the lid off the power. 6. After opening the cover should be the way to check the flameproof joint surface is intact, the rubber seal is hard or sticky, wire insulation is made of green and carbonation, whether insulation and electrical components deformed and scorch marks. These problems are found, it is timely maintenance and replacement. 7. Close the cover with a damp cloth before application (not too wet) wipe light fixture back light transparent parts, in order to improve the efficiency of light fixtures. In the proof should be combined with the surface coated with a thin layer of anti-rust oil 204-1 replacement, should pay attention to close the lid seal ring is played in its original position. 8. Lighting sealed sections should regularly disassemble and open.