How to deal with sewage wastewater treatment _ _ electroplating wastewater treatment process

 Fan with Chapter 丘丰跃 products, little of the fan noise, long service life. Fans were used in the process aeration system within 24 hours interchangeably. When adjusting the tank when the pump stops, the aeration blower interval of 2 hours 1 hour, 24 hours run single wind turbine automatically switch once, the process by the control system. 10.2, system-wide work program: 1), to stop the pump when water level below the water table, bed biological aeration fans to keep stopping half hour for ten minutes, and the pump can not be started. 2) When the sewage water level in the pump below the water level above the pump stops, the manual can start the pumps, fans run continuously alternates. 3), the sewage water level below the level at the time of the alarm, fan alternate work, pumps run continuously until the water level falls below the water pump stops after the shutdown. Since the control system has more functions and features, enable automatic operation of sewage treatment facilities within 24 hours, saving manpower how sewage treatment, sewage treatment and save energy, and to ensure that the sewage treatment to meet the design standards. (A) routine inspection of a factory, the equipment must be checked at the factory without any defect smelting waste water treatment, and check whether the components meet the regulatory requirements. 2, each pressure test equipment, leak testing without any anomalies. 3, check the device accessories and packing, inventory shipping list, confirm the correct one record after record. (B) field test in order to prevent damage to components and packaging protective paste (if any), shall not tear off in advance, must tear away from the scene after the whole installation. a. First on the equipment installation location and elevation detect whether the design requirements. b. equipment installation plan position deviation should be less than ± 20mm wastewater treatment sludge, elevation deviation is less than ± 20mm, both sides meet the design requirements. c. The equipment installation location should be accurate, its installation angle deviation is less than ± 10. d. Press the technical requirements for inspection and installation, to ensure compliance with its tolerance values ??specified index. E. Boot test, observe whether the abnormal equipment operation, the siphon system is normal, etc. how to deal with sewage wastewater treatment _ _ electroplating wastewater treatment process provided by the Environmental Protection Technology Co., Ltd. Shandong SafeNet. SafeNet Shandong Environmental Protection Technology Co., Ltd. (www.caftec.com.cn) strong, credible, Shandong Weifang exhaust gas treatment equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead the Environmental Protection Technology Co., Ltd. Shandong SafeNet and you hand into the brilliant, for a better future!