Jiangxi cartridge pulse dust collector supply the wind

The wind filter cartridge pulse structure :( multiple filtration area, can be customized according to requirements), the rain cover, upper, middle and lower barrel, cassette filters, electromagnetic pulse valve and impulse control instrument, blowing tube Road and other accessories. Air filter cartridge pulse cited works: upper body with the atmosphere through the barrel when the wind sent the compartment cement or other powder, due to the air pressure inside the cabin is greater than the pressure outside the warehouse, the filter inside and outside air pressure difference generated by the pulse analyzer Role and solenoid valve for intermittent injection cartridge to continue to clear the filter attached to the surface of the dust. Cartridge pulse dust collector uses an induced draft, adjust the pulse jet control device, locking pulse interval and pulse width, and complete all the electromagnetic pulse valve drive pulse cycle and cycle interval to ensure the running resistance of dust in the set within the scope of the implementation of the ESP dust cleared timing. 2, pulse dust collector at the warehouse roof were collecting, you should avoid direct powder tube to relieve pressure filter itself. 3. Remove the filter every 2-3 months will use dry air blowing in reverse filter dust collection, cleaning, in order to improve the life of the filter. Pulse dust collector cartridge installation requires an induced draft, box and hopper by locking bolts, leveling, site welding, soldering not leak. 2, the air bag may not leak pulse connection between the valve and the pipe. 3, the cartridge is installed first open the side cover, remove the injection tube, holding the cartridge catchy, the cartridge into the filter chamber through a fixed frame; then close the cartridge embedded in flower plate hole, tighten the bottom bolts so closely cartridge in the flower board; then check the tightness of the cylinder bore orifice plate with flowers; and finally the injection pipe installed, adjust the injection tube blowing holes in the bag so that the mouth center nut on the injection tube, Replace the cover. Cartridge pulse induced air filter compartment to stop the wind pulse cleaning technology to overcome the conventional pulse dust collector and sub-room cleaning dust shortcomings, the cleaning ability, high removal efficiency, low emission concentration, low leakage rate energy consumption, less steel consumption, small footprint, reliable, good economic returns. Suitable for recycling metallurgy, building materials, cement, machinery, chemicals, power, light industry, dusty gas purification and materials. Because the pulse induced draft air filter compartment stop pulse cleaning, blowing a thorough cleaning can achieve the purpose, so cleaning cycle extended, reducing the energy consumption of cleaning, compressed air consumption can be greatly reduced. At the same time, the degree of fatigue filter pulse valve is also correspondingly reduced, thus exponentially increase the life of the filter and valve. Use the wind cartridge pulse dust collector (1) to open the draft fan. (2) open air compressors, compressed air into the filter tank. And close the fan, while open pulse controller, carried out for blowing dust. The main control unit cartridge pulse dust collector of the wind. It outputs a control signal electromagnetic pulse valve, blow compressed air for cleaning bag progressive, so that the resistance to keep dust in the set