360 Cylinder | Hydraulic Lu (certified) | Cylinder

 (4) before unloading to try to create the conditions to prevent the discharge of hydraulic cylinder parts are dust and impurity contamination around. For example, should be demolished as possible in a clean environment; after the demolition of all the parts to use plastic sheeting to cover, do not use cotton or other work with a cloth cover. (5) After removing the hydraulic cylinder to be carefully examined to determine which parts can continue to use the fuel tank, which parts can be repaired before use, which parts must be replaced. (6) must be carefully cleaned before assembly of the parts. (7) around the sealing device to be installed correctly. ① When installing O-rings, do not pull their permanent deformation degree, do not side scrolling side suits, or it may form a distorted shape due to oil spills. ② When installing a Y-shaped and V-shaped ring, pay attention to the mounting direction to avoid spills installed instead. Y-shaped ring, its lips coping with pressure oil chamber; moreover, Yx-ring is also a distinction shaft or hole, do not install the wrong. V-ring shape different from supporting ring, seal rings and pressure rings, when the pressure ring compression seal ring, bearing ring seal ring can be generated as the sky-shaped seal, the seal ring should be installed for the opening pressure oil chamber; adjusting the pressure ring, should be limited so as not to leak, not too tight, sealed to prevent too much resistance. ③ sealing device such as a sliding surface fit, the assembly should be coated with an appropriate amount of hydraulic oil. O-ring seals and dust ring should be demolished after all the new ones ④. The most basic principle of the first five parts it: the cylinder and cylinder head, piston and piston rod seals, buffer device, exhaust. Each cylinder works are almost similar, take a manual jack, the jack in fact, is the most simple cylinder. By manually pressurized stalk (hydraulic hand pump) hydraulic oil through a one-way valve into the cylinder, then the hydraulic oil into the cylinder valve because of the individual can not go backwards back monaural cylinder, forcing the cylinder rod cylinder 360 upwards, and then continue to work constantly hydraulic oil into the hydraulic cylinder, and thus constantly on the rise, to fall when it opens an empty cylinder hydraulic valves, hydraulic oil back to the tank, this is the most simple works, the other is on this basis Improved cylinder cylinder with basically the same principle. 360 Cylinder | Hydraulic Lu (certified) | cylinders supplied by Lu of hydraulic equipment plant in Texas. Texas Lu force hydraulic machinery plant (www.luliyeya.com) is a leader in Dezhou, hydraulic machinery and parts, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs. Lu Hydraulic leadership with the staff warmly welcome all inquiries negotiations to create Lu hydraulic force a better future.