18990 Leybold Vacuum Pump Filter

18990 Leybold vacuum filter supplier, wholesale pricing, preferred exchange Guan Tao 18990 Leybold vacuum cleaner factory filter pump oil mist separator aka introduce exhaust filter is a built-in vacuum pump oil and gas separation device that can be drawn in a good vacuum gas oil separation, so that the vacuum pump exhaust gas pollution, meet environmental effects, and in some it may be a vacuum pump with a vacuum pump to reach eliminate noise function, because of its simple structure, cost reasonable, so by many pump manufacturers blitz. 18990 Leybold vacuum pump oil mist separator filter structure is usually paper, metal mesh, plastic cover both ends of the filter surface composition. Its core component is the inside of the filter paper, filter paper relatively good genus paper produced in Germany, with strong separation ability. 18990 Leybold vacuum pump filter works in the role of oil mist separator impetus, located on the side of the oil and gas mixture through the vacuum pump oil mist separator filter paper and cotton. Oil were trapped in order to achieve the separation process and vacuum gas oil operation. Are filtered out of the vacuum pump oil for recycling with the return pipe, exhaust emissions are oil-free, and achieve pollution, clean results. 18990 Leybold vacuum filter a routine maintenance check pump runtime: Use the vacuum gauges to detect oil mist separator is blocked, when the gauge is located in the red zone, indicating that the oil mist separator has been blocked and must be replaced. If there is no oil mist separator pressure gauge, the resistance of the oil mist separator changes by the drive motor current is measured, excessive consumption of the drive motor current or decrease the flow rate of the vacuum pump, the oil mist separator described clogged and must be replaced. b. If the vacuum pump oil mist separator pressure gauges indicated generally lower than, or drive motor current consumption is typically less than, because there is an oil mist separator is damaged, you need to replace the oil mist separator. c. If the gases contained in the oil, because the oil mist separator clogged or damaged, replace. Vacuum pump oil mist separator can not be thoroughly cleaned and must be replaced clogged oil mist separator Replace vacuum pump oil mist separator and pump off before disconnecting the power source to ensure that the vacuum pump has been through atmospheric pressure, open vent cover from the tank, With a dedicated six with a wrench to remove the exhaust filter, will be equipped with new seals the open end of the oil mist separator is installed in the correct position within the fuel tank vacuum filter manufacturers www.huitaolvye.com