PDC-200 Pipeline UV sterilizer 9
PDC-200 Pipeline UV sterilizer 9
Thanks for your interest in drinking water UV disinfection, UV disinfection of drinking 13,833,174,989 manufacturers Shijiazhuang Guanyu Environmental Protection Equipment Co., Ltd. is one of the production of the most professional manufacturers of sterilizer, the company produces the following features: www.gyzwx.com UV disinfection Features 1, use high-efficiency UV-C UV lamp selection of the world's leading high-strength low-pressure UV lamp, lamp life guarantee more than 12,000 hours. 2, the selection of high transmittance, high purity quartz tube, ensuring more than 90% of ultraviolet rays through. 3, use the advanced world of constant, high-intensity UV special ballast, to ensure that the entire system is operating normally in a complex case. 4, high quality stainless steel reactor (304 or 316), and the reactor wall for special polished to enhance the sterilization effect. Installation Considerations of a UV disinfection, should be installed horizontally (prohibited vertical installation). 2, the cylinder shall withstand external pressure. 3, at the outlet should be installed in the tank or water tower, Flow volume, high pressure or long pipe network while installed on close to the user's trunk (branch) is better. 4, extending outward from the ends of sterilizer, should be left ≥1 m ≥0.4 m space, in order to replace the lamp, should remain 0.6 meters of unobstructed space before disinfection control panel for easy maintenance. 5, regardless of the choice of one or more parallel disinfection, shall install a bypass pipe and valve for easy maintenance. 6, reasonable choice installation location, pay attention to the electronic control part of waterproof, moisture-proof. 7, according to the nameplate voltage, the power to select electrical outlet, wire or connector strips. 8, quartz glass tube and the UV lamp is a valuable fragile, transportation, installation, use should be avoided bump. UV disinfection equipment installation and operating procedures an ultraviolet disinfection installation and operation of the program: the unit horizontally mounted in the interior, the bracket or table specified by the foundation, (on the intake and outlet) sterilization equipment in the room position, in addition to considering the water up and down easily, meet the process requirements, but also pay attention to the installation position can be left out of the UV lamp and space, electric control box installed near the device, ambient relative humidity less than 80 ℃, non-corrosive gases, non-conductive dust, no strong vibration and shock. 2, ultraviolet disinfection installation: This product pipeline, two outlets to choose one according to the pipeline as the inlet, an outlet, as may be required horizontal and vertical placement according to the user, for ease of replacement lamps and quartz tube side to leave 1.2m space. After installing the product first water test, not leaking, then turn on the power, when the 3-5 minutes later to confirm the lamp light, hit the water valve, open the inlet valve, when the machine is running. 3, UV sterilizer maintenance: a quartz tube Removal: Turn off the power, open the sterilizer cover both sides, remove the tube, remove both ends of the gland, remove the "O" type rubber ring seal seat inside, then slowly out of the quartz tube. 2, the assembly of the quartz tube: the operator do not directly touch the surface of the quartz tube, so as not to dirty the impact of transparency on the positive ends of the quartz tube water sealing position, inserted into a quartz tube, the balance must be equal at both ends, set into "O" type apron, evenly and slowly tighten the gland, the intensity is not too large, so as to avoid a quartz tube rupture, then make water test, if leakage can then gently tighten the gland, to watertight until finally installed the lamp can be run.
Contact Detail
Company Name: | Shijiazhuang Guanyu Environmental Protection Equipment .. |
---|---|
Employee Number: | |
Annual export: | |
Year Established: | |
Contact Person: | Mr. Wang Tingting(Sales Manager) |
Telephone Number: | 0311-89832698 |
Company Address: | 398 Youyi North Street, Shijiazhuang City, Villa District 47-1, Shijiazhuang City, Hebei Province, China |
Zip/Postal Code: |
Find More Related Products
- Xie Gang thermal heat trans..
- Bridge thermal heat transfe..
- Import an old CNC machining..
- Huangpi District of Wuhan C..
- East thermal heat transfer ..
- Shek Pai thermal heat trans..
- PDC-200 over-flow UV steril..
- PDC-200 UV disinfection 4
- PDC-300 UV disinfection 9
- Shenzhenbuji lumbar disease..
- Bo Yang, Hebei car seat wit..
- Suzhou instrument import de..
- Tile export customs agents
- American Mold import process
- US DuPont PA66 70G33GRA BK3..
- Dongguan to the Long Island..
- Hua Hua _ _ Shenzhen, Dongg..
- Dongguan Offset Tang Hua, F..
- Dongguan Digital flocking |..
- Humen thermal heat transfer..
- High environmental heat tra..