Supply of water conservancy dedicated gate-PGZ flat-arched iron gate

Cast iron gate is used to close and open water conservancy construction activity over the water orifice. Widely used in water conservancy, hydropower, municipal construction, water supply, drainage, aquaculture and other projects. Gate Installation Notes 1, in front of the gate installation, first check all bolts loose joints are caused due to transport handling, if loose and should be tightened. 2, only the water main facade frame and cross-check the box if there is a link on the dislocation, dislocation if the connection is loose bolts adjust the water ended in the same plane. 3, the gate should be installed in place with the overall installation, prohibit gate frame, gate split installation, to prevent the gate frame deformation. 4, before pouring the second phase of the overall gate hoisting find a good back and forth about the correct position, then adjust the bolts with welded steel and engineering firm. 5, before the factory gates, in order to make the gate, the gate frame tighter fit after installation to reduce the gap, two meters above the gate of the upper and lower horizontal frame mounted pressure iron board, increasing the top of the vertical frame wedges wire. Note that the top wire gap adjustment card after removal of iron and wedges to make the gate opening and closing. 6, in the pouring of concrete, flowing into the gate, the gate frame, wedges, baffle gap mortar should be removed to prevent the mortar solidified impact hoist.