Belt scales, belt scales measure, Precision Electromechanical

Requirements for the feed belt scale equipment (1) When using the disc feeder mode, the discharge portion of the disc should be installed by the feeder speed belt scales, by the feeder discharge nozzle and installation should be equal to the drag and drop The cutting nozzle requirements (2) When using drag and drop to when feeding, cutting height adjustable nozzle material requirements at the same time the maximum height should be adjusted to meet the requirements of the accumulation of material flow. Meanwhile discharge nozzle should be made of the material surface slope along the material flow direction in order to exclude the shape of bulk materials. (3) When using drag and drop feed, the feed nozzle upper gate valve should be designed and installed conveyor belt scales, belt scales in order to facilitate maintenance and debugging. To ensure the belt that runs the stability and accuracy of measurement metering belt scales, requiring the outside gate valve with double plate, gate belt that engages in a consistent line conveying direction. The maximum opening of the gate is not less than the effective discharge nozzle discharge section. (4) upper hopper inlet port should be set to a grid or a grid of material, the material under the unit is not greater than the diameter of the discharge nozzle feeding equipment minimum working under minimum flow discharge height, to avoid blocking material cutting nozzle block . (5) When the device is operating ambient temperature and tap long time, if the moisture content of the material is sufficient to freeze into a block of material, heating measures should be adopted to take on the silo. Requires the installation of the conveying belt scale belt rollers ⑴ drag radial runout roller trailer, was dragged height, groove angle tolerances shall be permitted within the scope of the national standard. ⑵ drive system used in the amount of belt conveyor idlers and idler original size must be the same groove angle must be the same. Roller (3) Center for conveying belt-driven, can be installed at a distance of 8 drag roller weighing paragraph spacing where the belt scale installation of conveying belt rollers requirements ⑴ drag radial runout roller trailer, was dragged height, groove angle tolerances shall be permitted within the scope of the national standard. ⑵ drive system used in the amount of belt conveyor idlers and idler original size must be the same groove angle must be the same. (3) Center for conveying belt-driven roller can be installed at a distance of 8 drag roller weighing paragraph spacing place belt scales, belt scales measure, provided by the fine finishing of Electrical and Mechanical Electrical and Mechanical. This information consists of: providing a fine of Electrical Technology Co., Ltd. Weifang (www.sdjdkj.com), we are business alliance member, the integrity of the whole network authentication provider. Feel free to contact us, Contact: Miss Fu