Supply of laminated rubber bearings

Laminated rubber bearing an annual average temperature should be chosen when, in accordance with the design drawings must also indicate the location of the center bearing is properly seated, and to ensure support and the upper and lower part of the close contact between the structure shall not be voids. Supports should be installed horizontally, when you must tilt the installation, the maximum longitudinal slope should not exceed 2%, and in the choice of support, we should consider the need to increase due to tilt installation shear deformation effect, when longitudinal slope greater than 2%, To take measures to support level home. Two bearings should consider replacing, remove and easy to install. Any case, two or more bearings to allow the beam along the center line of the same anchor mounted side by side on a common beam, can not be provided with more than two lateral supports, different specifications can not allow the seat mounted side by side and construction to ensure that each bearing uniform force. 3 Select the bearing capacity, the possible reaction forces and bridge actually coincide, but should not be used more than the actual bridge pivot bearing reaction forces much larger size. 4 Note that size and embedded steel beam bottom anchor bolt locations. Embedded steel beam bottom size and thickness, the design may be based on the actual needs of their own determination, usually slightly larger than the abutment plate size is appropriate. Construction of the need to ensure that the anchor bolts embedded steel beam bottom position and stand on the plate and the lower support plate placed on the pier at the anchor bolt locations are accurate. Hengshui Lake District Runfeng Engineering Rubber Factory Address: Hebei Hengshui Lake District Tel :0318 -2253393 Fax 0318 -2253393 Mobile: 13803183913 15132890028 Contact: Manager Wang Website: www.hsrfxj.com