Tai Seng the CLB insulation gear pump rational design of longer life

 Of Tai Shing CLB insulation gear pump the rational design life longer CLB asphalt insulation gear pump used for pumping, conveying and spraying hot asphalt (residual) liquid can also be used at room temperature for suction conveying non-volatile, low flash point of petroleum products, such as oil, mechanical oil, and heavy oil. The insulation rotary gear pump, pump body, chassis, drive gear, driven gear and safety valve body, the drive shaft of oil by an additional sleeve support, supplemented by oil cup HG-24 saturated cylinder oil lubrication. Fitted on both sides of the gear pump with a tapered pipe thread connector for connection to the inlet duct bit, the tapered pin Built internally threaded in order to facilitate disassembly; the sealing pad of paper is further configured to adjust the gear axial gap, the gap requirements unidirectional between 0.05-0.08mm. The lower part of the base has four holes for installation, insulation gear pump with safety valve, the factory has the set working pressure of 1 - +0.05 MPa and seals. Asphalt insulation gear pump, the medium in the suction chamber, through the rotation of the gear, the media pressed into the drain chamber and outflow of hand wheel adjustment can change the output flows, when turning the handwheel to the right, the safety valve is to open the top, the pump lost output pressure and stop the drain; Rotate Left hand wheel, the safety valve will resume the role of the normal output of the media. The asphalt heat gear pump is mainly used for pumping, conveying and spraying high-temperature asphalt (residue) liquid optimum asphalt for roads and squares of the building works (residue) spraying operations can also be used at room temperature for pumping absorption, transport non-volatile, low flash point of petroleum products, such as all kinds of oil, machine oil and heavy oil. Read more about the the asphalt heat pump heat pump asphalt insulation gear pump