Weinan plastic mold | injection molding processing security equipment mold precision mold manufacturers

Weinan plastic mold | injection molding processing security equipment mold precision mold manufacturer of Xi'an plastic mold factory integration of universities, research institutes, all advantages of military enterprises, the factory mainly undertake mold design and processing of various types of products, pieces of plastic injection molding, plastic products processing and non-standard equipment design, processing and installation and commissioning. The factory mainly engaged in the processing and production of all kinds of stamping dies, injection molds, blow molds, die-casting mold design and well-equipped technical professional. Safety Tips for mold design structure should guarantee the feed given material out pieces to clean up scrap convenience. For the machining of small parts to non-operator's finger, wrist or other parts of the body extends into the mold area operations. For large parts of the processing, if the operator must work hand into the mold, to minimize into the mold range as much as possible to shorten the time a certain part of the body to stay in the mold, and mold dangerous area should be clear, with the necessary protective measures and devices. Mold on the various parts should have sufficient strength and rigidity to prevent damage and deformation in the process of using the fastening parts have anti-loosening measures to avoid accidental injury to the operator. Occur scrap or workpiece missile phenomenon is not allowed in the process, affect the operator's attention, and even injuring the operator. Also to avoid punching burr cut staff. Operator is not allowed during the stamping operation over a large range of motion, to avoid the posture of the body loses its stability. Does not allow the job too much and too difficult action. Stamping machining should be avoided when there is a strong noise and vibration. Mold design should be marked on the General Plan mold weight, ease of installation, and security. Parts processing more than 20 kg should be lifting handling measures to reduce labor intensity. Dismantle the mold parts should be easy and safe, and may avoid folders in hand, to cut the hand. Mold to facilitate the disintegration of storage. In short, the mold even minor issues will affect the safety analysis of the specific problems of each job, in order to put forward the safety precautions in the mold. Company website http://www.xashmj.com/ http://cn.plasticmould.net/company/sanhuan/ Customer: 1206461319 1549587214 Tel :029 -82,379,811 this welcome to consult